Perspectives · Robotics and Embedded Systems

Robot Sensor Calibration: Why Raw Numbers Are Not Yet Measurements

Robot Sensor Calibration: Why Raw Numbers Are Not Yet Measurements. Practical guidance on design trade-offs, common failure modes, and how to validate a real embedded robotics project.

Robot Sensor Calibration: Why Raw Numbers Are Not Yet Measurements

Offset and scale factor link raw readings to physical quantities. Assembly matters: an IMU may be rotated, a magnetometer disturbed by motor current, or an ADC divider different from its nominal value.

Where real systems fail

Filtering reduces some noise but cannot correct systematic error. Calibration performed on a bare board may not hold after sensors are mounted in the chassis.

How to validate the design

Calibrate the assembled system, validate against known references, test across the operating range, and store calibration with version and range checks. Treat corrupt calibration as a fault.

The engineering principle

A robot is a physical system controlled by software, not merely a program running on a board. Test assumptions against measurements, make failure states explicit, and verify behavior under realistic loads and timing. The most reliable design is the one whose limits are understood and whose response to faults has been deliberately engineered.

Share this article
Facebook WhatsApp X LinkedIn Medium
Quick navigationEsc